What should we do when we use a chamfer to cut wood?

First check whether the tail of the cardboard is not correct.

If the tail of the slitting board is not correct, it will cause an error in the cutting and positioning of the cutting blade of the chamfering machine. The slitting blade is too blunt, and the line speed of other blades will be different. It is the error of the paper guide wheel adjustment of the angle cutting machine blade; the error of the paper feeding of the angle cutting machine blade is incorrect. Finding local problems that require adjustment based on these situations will be resolved

。

There is also four problems with the burr of the angle cutter saw blade:

1. The chamfering saw blade is blunt and should be sharpened;

2, the angle of the saw blade and the sipe of the chamfering machine are too shallow to adjust to just the orientation;

3. The edge of the saw blade of the photo frame chamfering machine is wound with paper edges and paper hair, and it should be thoroughly cleaned and then turned on;

4. The gap between the sipes of the saw blade of the photo frame chamfering machine is too large. Generally, it should be no more than 2.5mm.

Article from: Angle cutter manufacturer http://www.saloncn.cn