There is a "triangular limit block" on the work surface of the photo frame nail angle machine, which needs to be adjusted in the middle. There are four screw holes on the work surface to fix the triangular limit block.

Take a cut wooden bar up. If the frame bar is too large, screw the two screws of the triangular stop block to the screw holes on the back. If the photo frame is small, you need to add two blocking bars to prevent the clip from damaging the small frame bar. After the adjustment of the stop block is almost adjusted, tighten the screws, and then adjust the work surface according to the orientation of the frame bar to be nailed.

Push the table and the frame back and forth. For example, to determine the orientation of the nails outside the frame, you need to adjust the large screw below the table to position it. After you have adjusted and positioned yourself, put the required nails into the nail groove.

If the mold head is uneven, loosen the screw on the mold head and replace it with a matching mold head. Put the corner nails, the glue side of the corner nails is facing up, and the convex side is facing the back of the machine. After putting the nails on, put the nail feeder on. The nail feeder in our factory is a spring with durability. The frame can be placed on the countertop.

The person is sitting in front of the machine, stepping on the foot pedal with the left foot, the clamp of the machine clamps the frame bar, and the pressing rod is pressed down together (be careful, your fingers should not be caught by the clamp). First hit the nails inside the frame strip, and use your fingers to grasp the two round bars in the middle of the frame strip or on the table surface. Push the table surface forward, don't release your left foot, and step on the nail frame with your right foot. Note: The person is working in front of the machine. Press the foot pedal with the left foot, and the clamps of the machine will clamp the frame bar, and the lever will be pressed down together (be careful not to get your fingers caught by the clamps). First hit the nails inside the frame strip, and use your fingers to grasp the two round bars in the middle of the frame strip or on the table surface. Push the table surface forward.

Article from: nail angle machine manufacturers  http://www.saloncn.cn